Wire-cutting is now widely used in many industries, so it also plays an important role in various fields. However, the processing of wire-cutting requires some conditions, not under any conditions. The following editor will tell you about the processing of wire-cutting. required conditions.

  1.When the wire is running during processing, the molybdenum wire and the template must keep a certain distance during processing, which can increase the friction surface, but the gap cannot be increased at will. It needs to be set according to certain data, including the working voltage, total workload, etc. , and then set the gap value reasonably.

  2.In the production of intermediate wire, the requirements for insulation are very high. When it comes to insulation, the characteristics of the insulating liquid medium must be considered. After considering the characteristics of the liquid medium, the influence of the battery in the gap and the cooling electrode can be better eliminated. . The important thing is to be able to spark discharge, so the fineness of the medium is also very high. If there is a voltage, the medium cannot be broken down. When the gap is too large, it may be that the gap is too large. In this case, the spark discharge cannot be generated. If a short circuit or connection is formed, the spark discharge cannot be generated at the same time, mainly because the gap is too small.

  3.In the production of the middle wire, the requirements for the power supply are also very high. The connected power supply cannot meet the processing flow, and it must be a pulse power supply. Such power supplies are pulsed and intermittent, so spark discharges can often be successfully generated, but if you want to eliminate some ionization conditions within the pulse interval, you usually draw a spark discharge diagram to help you better analyze and explain, Only when these conditions are met can a better complete work be produced.