When touching the new category, there are many things that you don't understand. There are some operating skills for wire-cutting machine tools in modern machining technology. It is easier and more convenient to control the machine tool, so that you can grasp the operation of wire-cutting machine tools more quickly. Tips. First of all, when cutting the workpiece with high machining accuracy in the middle wire.

  In the case of edge-to-edge processing, the calculated length of the cut should be added to the radius of the molybdenum wire. Due to the high precision requirements, although the molybdenum wire is very thin, in order to improve the accuracy and product quality, this error cannot be ignored. The molybdenum wire should be prevented from being cut off when the middle wire is cut by the machine tool. The working fluid in the water tank should be checked frequently, preferably once a day.
  The conductive block should also be checked regularly and on time. If it is found that the groove marks are too deep, it must be replaced. Because the groove marks are too deep, the cutting wire will be broken. If the cutting wire becomes a spiral, it needs to be replaced immediately, otherwise It will affect the quality of the cutting process products. When cutting a large workpiece with a wire-cutting machine, it depends on whether the length of the machine tool is enough for the workpiece to be cut completely.
  If the middle wire cutting machine tool needs to cut aluminum, and the amount of aluminum to be cut is relatively small, then you only need to prepare a shorter conductive block. During processing, brush ignition oil on the molybdenum wire every half an hour. It is to clean the oxidation on the molybdenum wire, and other things can also be used to remove the alumina on the surface. When cutting aluminum, the molybdenum wire can be kneaded into a ball, and then the ball can be flattened and placed on the guide block, very good. Use, the cost is also very low.